Our work across Taranaki
Systems Streamline Solar has designed and installed, with the panel counts, inverters and battery sizes for each one. From a 90.9 kW dairy cow shed to a city roof in New Plymouth.
Farms and agriculture

90.9 kW on a dairy cow shed, Waitotara
Part two of three at Pukeone Farm, a generational dairy milking about 1,000 cows. The shed roof runs east to west, so the east side covers morning milking and the west holds generation into the afternoon. That spread suits a shed running early and late rather than a midday peak. Sized for the real loads: milking, milk chilling, grain smashing and water heating.
- System size
- 90.9 kW DC
- Panels
- 180 × 505 W
- Inverter or battery
- Sigenergy 99.9 kW hybrid inverter
- Where
- Pukeone Farm, Waitotara

62.64 kW for pivot irrigation, Waitotara
Part three at Pukeone. The pivots run through the high-sun months, so the load lines up with generation. The inverter is deliberately oversized against the array, which lets the farm add panels later without swapping the unit. Irrigation here is 50 kW of pumps running 24 hours a day through summer.
- System size
- 62.64 kW DC
- Panels
- 108 × 580 W
- Inverter or battery
- Sigenergy 99.9 kW inverter, sized for expansion
- Where
- Pukeone Farm, Waitotara

35 kW on a 400-cow dairy shed, Inglewood
A family dairy running about 400 cows, where shed power was only going one way. North-facing shed roof, installed between milkings so the herd and the roster were barely interrupted. Every panel has its own microinverter, so a dirty or shaded module does not drag the rest down, and output is monitored panel by panel. Hayden estimates payback on power savings at around five years.
- System size
- 35 kW DC, 27.0 kW AC
- Panels
- 70 × 500 W
- Inverter or battery
- 70 × Enphase IQ8HC microinverters, 25 year replacement warranty
- Where
- Inglewood

31.32 kW for farm homes and workshops, Waitotara
Part one at Pukeone. Centralised metering meant a single system could feed several homes and workshops, so the array went in the paddock beside the meter. Short cable run, no roof work, easy to service. Solar covers the day and the battery covers the evening and blackouts, so the houses stay up when the lines go down.
- System size
- 31.32 kW DC
- Panels
- 54 × 580 W
- Inverter or battery
- Sigenergy 20 kW inverter, 27 kWh Sigenergy battery
- Where
- Pukeone Farm, Waitotara

Solar on a coastal sheep and beef farm, North Taranaki
A dry stock farm in coastal North Taranaki with several homes on the property. Streamline combined the power supply onto one centralised meter, so the farm pays one line charge instead of a bill for every house, then sized a rooftop system to match. Sea spray and corrosion decided the kit: Maxeon panels for the solid copper backing, and an inverter at each panel rather than one string box on a wall.
- System size
- 13.5 kW DC
- Panels
- 30 × 450 W SunPower Maxeon
- Inverter or battery
- Enphase microinverters, one per panel
- Where
- Coastal North Taranaki
Homes

14.14 kW on a flat roof, New Plymouth
A flat-mounted array, which sits at a lower tilt than a pitched north-facing roof and generates less per panel as a result. The answer was more capacity plus module-level conversion. Each panel has its own inverter, so one weak module or a patch of shade does not pull a whole string down. Residential solar on a difficult roof.
- System size
- 14.14 kW DC, flat mounted
- Panels
- To be confirmed
- Inverter or battery
- 10.5 kW Enphase microinverters
- Where
- New Plymouth

12.6 kW on a coastal home, Oakura
A coastal home with a roof that already faced the right way, so the job was about sizing rather than engineering around a bad pitch. Good sun, a clean north-facing plane, and daytime load that matches a solar day. The brief was cost-neutral living, not an oversized array on the wrong roof.
- System size
- 12.6 kW DC
- Panels
- To be confirmed
- Inverter or battery
- Sigenergy 10 kW single-phase hybrid inverter
- Where
- Oakura

12.24 kW ground mount with EV charging, Okato
A rural block where the client wanted a ground mount they could build themselves. Streamline did the electrical design, the gear, the cabling, the grid connection and the sign-off. The client fabricated and erected the frame to that design. It sits at the angle and orientation designed for the site and winter sun. No battery on this one, the brief was generation and charging, but the inverter can take storage later.
- System size
- 12.24 kW ground mount
- Panels
- 24 × 510 W
- Inverter or battery
- Sigenergy 10 kW hybrid inverter, Sigenergy 7 kW EV charger
- Where
- Okato

8.1 kW and battery on a city roof, New Plymouth
A home in central New Plymouth. City roofs give you less area and city households use more in the evening, so the array fits the available plane and the battery does the shifting. Daytime solar goes into storage and comes back out after work, so the house is not buying peak units at the worst time of day.
- System size
- 8.1 kW DC
- Panels
- 18 × 450 W
- Inverter or battery
- Sigenergy 6 kW inverter, 15 kWh battery
- Where
- New Plymouth CBD

Off-grid solar on a coastal clifftop
A home on the cliff at Tongaporutu running fully off grid, with no grid backup at all. The array sits on the side of the cliff, so access, structure, wind loading and cable routes were all non standard. Hayden describes it as a design that did not come out of a catalogue.
- System size
- 10.1 kW DC
- Panels
- 20 × 505 W panels
- Inverter or battery
- Sigenergy 10 kW inverter, 27 kWh Sigenergy battery
- Where
- Coastal Taranaki

12.8 kW and 27 kWh on a new build, Lepperton
A modern new home on the New Plymouth side of Lepperton, with the load to match: heat pumps, induction, and wired for an EV. Hayden describes it as the kind of house where a battery stops being a nice extra and starts making economic sense. Solar covers the day, the battery takes the evening peak and the overnight and morning draw.
- System size
- 12.8 kW DC
- Panels
- Roof mounted array, sized to the roof and the load
- Inverter or battery
- 10 kW Sigenergy hybrid inverter, 27 kWh Sigenergy battery
- Where
- Lepperton, New Plymouth

54 kWh of storage on a large Westown home
An existing solar home that had outgrown its battery. Streamline kept the array that was already there and added to it, stripped out the Tesla Powerwall and Gateway, and replaced the lot with a single Sigenergy stack. The result is a three phase system with more than fifty kilowatt hours of usable storage behind it.
- System size
- Existing array retained and extended, total to be confirmed
- Panels
- Existing panels kept, further panels added
- Inverter or battery
- SigenStor EC 20.0 TP, 20 kW three phase, 4 MPPT, up to 32 kW PV. 6 × BAT 10.0, 54.24 kWh nominal and 52.56 kWh usable
- Where
- Westown, New Plymouth
Business and community

18 kW and 27 kWh at the former Riverlea School, South Taranaki
The old Riverlea Primary School, inland from Hāwera, now in new use. It needed a system that worked on day one and could grow without replacing the inverter. The 20 kW inverter is not maxed out by an 18 kW array, and that headroom is the point. More panels and more battery modules can be stacked later on the same platform, app and grid connection.
- System size
- 18 kW
- Panels
- To be confirmed
- Inverter or battery
- Sigenergy 20 kW 3-phase hybrid inverter, 27 kWh Sigenergy battery
- Where
- Former Riverlea Primary School, South Taranaki

16.16 kW, battery and EV charging at Ruru House, Lepperton
Ruru House is a purpose-built early learning centre just outside New Plymouth. Three-phase supply, so a 3-phase inverter matches it without splitting the job across single-phase gear. Panels produce while the centre is open, surplus charges the battery for late afternoon, and the car park charger draws from solar first, then the battery, then the grid, all on one system and one app.
- System size
- 16.16 kW
- Panels
- 32 × 505 W Suntech
- Inverter or battery
- Sigenergy 15 kW 3-phase inverter, 18 kWh battery, 11 kW 3-phase EV charger
- Where
- Ruru House, Lepperton
11 kW and 18 kWh for Te Rau o Rongo Charitable Trust, Onaero
A Sigenergy solar and battery system at the Trust’s kai maara in Onaero. It powers their whenua-based mahi, growing kai, running programmes and supporting whānau, while cutting grid costs and keeping essential loads running once the sun goes down. Built for a community site that needs reliable power, not just a lower bill.
- System size
- 11 kW
- Panels
- Suntech 475 W
- Inverter or battery
- 10 kW Sigenergy hybrid inverter, 18 kWh Sigenergy battery
- Where
- Onaero, North Taranaki

12.32 kW, 18 kWh and solar hot water for Ember Heating, Lepperton
A 10 kW Sigenergy hybrid system for Ember Heating’s premises. Hot water runs off the Sigenergy smart port on its own schedule, so the cylinder heats from solar and stored energy instead of drawing from the grid at peak times. Lower running costs, with power and hot water still available after dark.
- System size
- 12.32 kW DC
- Inverter or battery
- 10 kW Sigenergy hybrid inverter, 18 kWh battery, hot water on the smart port
- Where
- Lepperton
Seen one like yours?
The assessment is free and it comes first. We come to the property, look at the roof and the switchboard, and size it to what you actually use.


